Cooper Menvier SD3 Spezifikationen PDF herunterladen (Seite 11)

Programming SD1+

Option 7: Call Routing

You can program messages A, B, C or D so that they

report to one or more of the four telephone numbers. For

example: message A might report to telephone numbers

1, 3 and 4, but NOT to number 2.

1. If necessary initialise the SD1+ .

SD1+

2. Key in the current passcode.

READY

3. Press 7, the display shows:

ROUTE-

4. Press [.

The display shows the telephone numbers that

message A reports to. In the example on the right,

message A goes to telephone numbers. 1 and 3.

A)1-3-

5. Press 1, 2, 3 or 4 until the display shows the

telephone numbers that you want the message A to

go to, for example:

A)-2-4

6. Press B repeatedly to see what destinations the

other messages go to, for example:

C)---4

7. Repeat steps 5 and 6 until you have allocated all the

messages to their correct telephone numbers.

8. Press [ to accept the new option and return to

“READY”.

READY

SD1+ Installation

Commissioning

Once you have made all the necessary connections, fit the cover back

onto the base and apply power to the SD1+.

When you power up a new SD1+ for the first time the

memory is blank: there are no stored telephone numbers

or messages. When there are no stored messages or

telephone numbers the display shows:

PLEASE

RECORD

Key in 1234.

The SD1+ is now in programming mode. The display

shows:

If you do not operate the unit for 60s then it will leave

programming mode by itself. Simply key-in the

passcode again to re-enter programming mode.

READY

If you are unfamiliar with programming a SD1+, then here

is a list of the minimum items you must program in order

to get the unit working.

Store the telephone number of the person you wish

to receive the message (page 14).

Record Phrase 0, giving the location of the unit, or of

the equipment being monitored (page 18).

Record a phrase for each input A, B, C or D that is

connected to the unit (page 18).

Test the message and destination by starting a test

call (page 28).

Tell the person who is going to receive the call how

to acknowledge it (press ‘8’ on their telephone

keypad, see page 3).

If you wish to allow a user to abort a call then see

page 25.

Once you have finished programming and testing the

unit, press ] until the display shows:

SD1+

The SD1+ is now in standby mode, ready for operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Menvier SD3 Spezifikationen Seite 11

Kommentare zu diesen Handbüchern