Cooper Menvier SD3 Spezifikationen PDF herunterladen (Seite 6)

Introduction SD1+

You can program the SD1+ to activate the output for one of the following

conditions:

The unit has been triggered and is making calls. The output is active

from the trigger event until the last required acknowledgement, or

until the whole series of calls has failed.

A call has been successfully acknowledged. The output is active for

seven seconds when the unit receives the last required acknowledge

signal.

The SD1+ failed to communicate. The output is active for seven

seconds when the SD1+ finally stops calling.

SENDING A TEST CALL

Once programmed you can test each message by sending it to a selected

telephone number. When the unit is in test mode the speaker relays

everything that the unit sends over the telephone line, and the display gives

a visual indication of what is happening.

PASSCODE

To enter programming mode or to cancel calls you must key in a passcode

at the keypad. The passcode is normally four digits long, but if necessary

you can program the SD1+ to accept six-digit passcodes for greater

security.

Specifications

Power input: 11.5V - 14V

Current consumption: 35mA (standby); 70mA (Active)

Trigger inputs: A, B, C, D (+ve or -ve applied, input voltage 5 -

28V)

Phrases A,B,C,D,0: 25 seconds ± 2 seconds each, sampled at 8KHz

Telephone Numbers: 4 x 24 digit telephone numbers

Case dimensions: 150(L) x 104(H) x 30(D) mm

REN value: 0

SD1+ Programming

Display Messages

PLEASE

RECORD

The unit has no stored messages or telephone

numbers.

SD1+

Either: The unit is in normal standby OR: the unit is

dialling out after an input has triggered it.

ABORTED

A user keyed in a passcode to abort a call while the

SD1+ was attempting to dial out. The unit displays this

message for aborted activations, but NOT for aborted

test calls.

The unit displays the following messages during a test call, but NOT

during a normal activation:

RINGING

The unit has detected a ringing signal on the telephone

line.

ENGAGED

The target phone is engaged. Wait until they have

finished and try again.

UNOBTAIN

The unit has detected the Unobtainable or Special

Information Tone. Check that the number is correct

and try again.

SENT OK

The unit dialled out, sent the message and was

acknowledged correctly by the recipient.

NO REPLY

The call was not answered or acknowledged by the

recipient.

PAGED

If you have programmed the unit to send a pager

number, the SD1+ will show this message when it has

sent the pager message.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Menvier SD3 Spezifikationen Seite 6

Kommentare zu diesen Handbüchern