Cooper Menvier SD3 Spezifikationen PDF herunterladen (Seite 4)

Introduction SD1+

RECORDING MESSAGES

The SD1+ has a built in microphone to let you record messages directly

into the unit.

Each message comprises two phrases: a common phrase (labelled ‘0’)

and one of phrases A, B, C or D. The common phrase normally tells the

recipient where the message comes from, and the second phrase tells the

recipient what input has been activated.

Each phrase can be up to 25 seconds long.

PLAYING BACK MESSAGES

The unit’s built-in speaker lets you hear any of the recorded messages.

When you play a message, the SD1+ always plays phrase 0 first.

TELEPHONE NUMBERS

The SD1+ can store up to four different telephone numbers, each one up

to 24 digits long. You can program and check the numbers from the unit’s

keypad and display.

The SD1+ uses pulse or tone dialling, and you can insert pauses for slow-

responding exchanges.

You can also program the SD1+ to send numerical messages to pagers.

The unit adds a single digit at the end of the pager message to indicate

which input has been triggered.

DELETING MESSAGES AND TELEPHONE NUMBERS

The SD1+ stores the recorded messages and telephone numbers

internally, and you cannot delete them simply by removing the power

supply. A programming option allows you to delete all messages or

telephone numbers at once if you wish to do so, or you can delete them

individually.

CALL ROUTING

You can program the SD1+ so that each trigger input will send its

associated message to any of the stored telephone numbers. For

example, if you wish the unit to call four different numbers under three

different conditions you could program trigger A to call telephone number

1, trigger B to call telephone numbers 2 and 3, and trigger C to call

telephone numbers 1, 2, 3 and 4.

SD1+ Programming

Problem Possible Cause Action

The recipient can’t

acknowledge the call

with a mobile phone.

Weak reception or

incompatible telephone.

Mobile phones will only work

correctly if they are used in an

area where the reception is good.

The recipient has

acknowledged the call

but the SD1+

continues to dial the

second, third or fourth

number.

The “CLEARBY” option is

set to: “ANY-2” or “ANY-

3” or “ALL-4”

Check that the option is at the

required setting.

I am pressing the [

key for 6 seconds, but

I cannot get the

“READY” prompt and

the display still shows

“PLEASE RECORD” or

“SD1+”.

You must key in a four

digit passcode to gain

access to the

programming menu.

Enter your user passcode (page

11).

1 2 3 4 5 6 7 8 9 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Menvier SD3 Spezifikationen Seite 4

Kommentare zu diesen Handbüchern