Cooper Menvier SD3 Spezifikationen PDF herunterladen (Seite 3)

Programming SD1+

NOTES:

SD1+

Introduction

This manual describes how to install and program all SD1+ units

manufactured after June 2008. Note that the programming menu for units

made after that date is slightly different from the menu in older versions of

the SD1+, and the recording time has been lengthened to 25 seconds per

message.

Overview

The SD1+ sends pre-recorded voice messages over a conventional

telephone line whenever external equipment triggers one of its four inputs.

Any equipment that has a voltage-free contact as an output can provide an

input to the unit. Each input, labelled A, B, C or D, triggers the

corresponding stored message A, B, C or D. In the example shown below

these inputs are: A- fire, B- Personal Attack (PA), C- Burglary and D-

Auxiliary.

Speech Dialler

Telephone

Auxiliary

Input

BT Line

Tel No 2

Tel No 3

Tel No 4

Tel No 1

ENT

ESC

SD1+

Alarm system control

unit (or other

equipment)

The SD1+ also requires a 12VDC supply. Alarm control units, for example,

often provide such a supply for connected equipment.

When connected to a telephone line the SD1+ behaves like another

extension and does not normally affect the operation of any telephone or

other equipment also connected to the line. While the SD1+ is sending a

voice message other users on the line will hear it should they lift their

handset.

1 2 3 4 5 6 7 8 ... 17 18

Keine Kommentare

Cooper Menvier SD3 Spezifikationen Seite 3