Cooper Menvier SD3 Spezifikationen PDF herunterladen (Seite 12)

Installation SD1+

While the SD1+ is in standby the display continues to

show “SD1+” You can re-enter programming mode if

you need to by keying in the passcode.

When the SD1+ is making a call, the display continues to

show “SD1+” but the unit will not allow you to enter

programming mode. If you have programmed the unit to

allow a user to abort the call, then entering the passcode

will stop the call immediately.

The following pages tell you how to program the unit in

more detail, and how to set up some of the more

complex functions.

SD1+ Programming

Option 6: Programmable Output

The SD1+ has a single output. Using option 6 you can

program this output to operate under one of the

following conditions:

a) When an active input triggers the unit (the display

shows this as “ACTIVE”).

b) When someone acknowledges a call from the SD1+

(shown as “SUCCESS”).

c) When the SD1+ has dialled all numbers but has NOT

been acknowledged (shown as “FAILED”).

If you wish to disable the output, you can set it to

“OFF”.

1. If necessary initialise the SD1+ .

SD1+

2. Key in the current passcode.

READY

3. Press 6, the display shows:

OUTPUT-

4. Press [.

The display shows the current output type, for

example:

ACTIVE

5. Press B. until the display shows the output type

you want to use, for example:

SUCCESS

6. Press [ to accept the new option and return to

“READY”.

READY

Note: If you select FAILED, and also set the acknowledgement option

to NO-ONE (see page 27 ) then the output will not operate.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

Cooper Menvier SD3 Spezifikationen Seite 12