Cooper Menvier SD3 Spezifikationen PDF herunterladen (Seite 7)

Programming SD1+

Options ABCD: Testing Messages

To test a message and it’s telephone numbers:

1. Make sure the SD1+ is not currently sending any

messages.

SD1+

2. Key in the current passcode.

READY

3. Press either A, B, C or D depending on which

message you want to test. The display shows, for

example “SEND A” alternating with “ON 1-4”:

SENDa A

ON 1-4

EITHER:

A) Press A.

The unit plays message 0 followed by message A.

The display shows, for example “PHRASE A”:

PHRASE A

If you wait five seconds without pressing a key then

SD1+ plays message 0 followed by the message

associated with the key you pressed in step 3.

Once the SD1+ has finished playing the messages

the screen shows “READY”:

READY

OR:

B) Press a digit 1 to 4. The SD1+ sends message 0

and the message A (or B or C or D depending on the

key you pressed in step 3) to the telephone number

you selected (1 to 4).

Note: Ask the person answering the call to

acknowledge the message by pressing ‘8’ on their

phone keypad. Otherwise the SD1+ will work

through a complete cycle of four calls for that

message.

SD1+

Installation

Installation Requirements

The SD1+ is designed for connection to an intruder alarm control panel or

similar equipment. The control panel must have an auxiliary power output

of between 11.5V and 14V, with the ability to provide a minimum of

100mA.

Cooper Security supplies the SD1+ with a 2 metre telephone lead which

will plug directly into any standard BT socket. Cooper Security recommend

that you site the SD1+ as near to a BT telephone socket as possible. If this

it not possible you can either use an approved BT extension lead or wire

the unit to the BT. socket (see page 8).

Mounting Instructions

1. Separate the cover from the base by using a screwdriver to push two

of the retaining clips (top or bottom) inwards from the base indents.

Remove cover assembly and store in a safe place.

2. Hold the base in position (keyhole to the top) and mark the three

securing holes. Remove the base then drill and plug the holes.

3. Pass all cables into the base through the cable entries and then secure

the base to wall.

PCB Layout

1. Loudspeaker

2. Tamper Switch

3. Microphone

4. Tamper connections (SELV)

5. Trigger Inputs (SELV)

6. Trigger Polarity jumper

7. Telephone Connections (TNV)

8. 12V Supply and Programmable

O/P (SELV)

9. Factory Restart Pins

SELV = Safety Extra Low Voltage, TNV= Telecommunications Network Voltage.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare

Cooper Menvier SD3 Spezifikationen Seite 7

Kommentare zu diesen Handbüchern